Download

Get Vendoke for Android and Windows, with firmware and tools for the coin acceptor.

Firmware

ESP32 and ESP8266 coin acceptor firmware.

🔌

ESP32 Bluetooth coin acceptor firmware1.0

Coin acceptor firmware for ESP32 that connects to the Vendoke Android app over Bluetooth (BLE). • Counts the pulses from your coin acceptor and sends the total to the tablet • Bluetooth name: KaraokeTab. Pair it in the app: Admin, then Binding • Coin signal on GPIO 15, coin inhibit on GPIO 2 (easy to change at the top of the file) • The app turns the coin acceptor on only while a song is waiting for a coin For Vendoke for Android only. For a Windows PC use the ESP32 COM port firmware instead. How to flash: open the .ino file in the Arduino IDE, choose the board "ESP32 Dev Module", connect the ESP32 with USB and press Upload. DIAGRAM PIN - Coin pin: 15 - Set pin: 2 - Ground: GND

Download firmware
🔌

ESP32 COM port coin acceptor firmware1.0

Coin acceptor firmware for ESP32 that connects to Vendoke PC (Windows) with a USB cable. • Counts the pulses from your coin acceptor and sends the total as a line like {"c":12} over the COM port (115200 baud) • Coin signal on GPIO 15, coin inhibit on GPIO 2 (easy to change at the top of the file) • The coin acceptor is enabled as soon as the ESP32 starts • No Bluetooth and no Wi-Fi needed For Vendoke PC only. For the Android app use the ESP32 Bluetooth firmware instead. How to flash: open the .ino file in the Arduino IDE, choose the board "ESP32 Dev Module", connect the ESP32 with USB and press Upload. How to use: leave the ESP32 plugged into the PC, then in Vendoke PC open Admin, then Binding, and choose its COM port. DIAGRAM PIN - Coin pin: 15 - Set pin: 2 - Ground: GND

Download firmware
🔌

ESP8266 COM port coin acceptor firmware1.0

Coin acceptor firmware for ESP8266 (NodeMCU / Wemos D1) that connects to Vendoke PC (Windows) with a USB cable. • Counts the pulses from your coin acceptor and sends the total as a line like {"c":12} over the COM port (115200 baud) • Coin signal on D5, coin inhibit on D6 (easy to change at the top of the file) • Understands coins of different value from the number of pulses (1, 5, 10 and 20) • The coin acceptor is enabled as soon as the board starts • No Wi-Fi needed For Vendoke PC only. How to flash: open the .ino file in the Arduino IDE, choose the board "NodeMCU 1.0 (ESP-12E Module)", connect the board with USB and press Upload. How to use: leave the board plugged into the PC, then in Vendoke PC open Admin, then Binding, and choose its COM port.

Unavailable